Operation; Starting Up The Dental Treatment Unit; Initial Startup; Switching The Dental Treatment Unit On/Off - Sirona teneo Operating Instructions Manual

Sirona Dental Systems GmbH

Operating Instructions (USA) TENEO
T E R
W A
A IR
A 0 ~
x .6 H 2 5
M a
.3 A
e T 6
F u s
A
65 48 510 D3509
D3509.201.03.03.23 10.2016
4

Operation

4.1

Starting up the dental treatment unit

4.1.1

Initial startup

Sanitation must be performed prior to initial startup of your dental
treatment unit.
This is done by filling all water-bearing lines with DENTOSEPT P
concentrated waterline treatment solution to reduce the exposure of the
water to bacteria.
If the service engineer skipped the sanitation procedure after installing
TENEO reference
your dental treatment unit based on an agreement with you or sanitation
has not been performed for more than one week, please perform
sanitation yourself. Refer to "Sanitizing the dental treatment unit" [ → 248]
for more information.
Sanitation takes 24 hours.
4.1.2

Switching the dental treatment unit on/off

The dental treatment unit is equipped with a standby system for
enhanced convenience when switching it on and off at the dentist
element.
The dental treatment unit thus features a power switch at the base of the
chair and a main switch on the dentist element.
4.1.2.1

Power switch

The power switch connects the dental treatment unit to the power supply.
During longer periods of disuse, the dental treatment unit should be
disconnected from the power supply. It then no longer consumes any
energy.
The power switch contains an automatic device fuse.
Connecting the dental treatment unit to the power supply
✔
The dental treatment unit is installed by authorized technical
personnel according to the "Installation Instructions".
➢ Turn on power switch A.
 The dental treatment unit is connected to the power supply.
Disconnecting the dental treatment unit from the power supply
✔
The dental treatment unit is shut down, see "Switching the dental
treatment unit off" (below).
➢ Turn power switch A off.
 The dental treatment unit is disconnected from the power supply.
4 Operation
4.1 Starting up the dental treatment unit
43