Sirona teneo Operating Instructions Manual page 129

Sirona Dental Systems GmbH
Operating Instructions (USA) TENEO
0
65 48 510 D3509
D3509.201.03.03.23 10.2016
Activating NaCl rinsing via button on foot control
✔
NaCl rinsing
The key is displayed in the
➢ Press the right button of the foot control.
 The NaCl rinsing function remains active as long as the key is
pressed.
Switching the torque signal on/off
This can be used to set the acoustic signal that sounds whenever 75% of
the currently set torque value is exceeded.
Acoustic Signal
➢ Touch the
 If the key is highlighted orange, the torque acoustic signal is
activated.
Setting the foot control as a direct starter or speed foot control
The foot control can be set as a direct starter (key highlighted gray) or as
a speed (key highlighted orange) foot control.
For details, see "Setting the foot control as a direct starter or speed foot
control" [ → 90].
Setting the number of work steps
The number of implantology treatment work steps, e.g. predrilling, final
drilling, tapping, etc. can be set. Up to eight work steps can be preset.
➢ Use the – and + keys to set the number of work steps.
 The number of work steps is displayed on the left side:
Implant 1... X.
Saving settings
The following settings can be saved for the selected work step in the
Implantology program
:
● Speed and torque [ → 125]
● NaCl cooling and NaCl cooling amount [ → 126]
In addition, the system will save the following settings that apply to the
entire treatment:
● Number of work steps [ → 129]
● Presetting of NaCl rinsing and NaCl rinsing amount [ → 128]
● Foot control as a direct starter or speed foot control [ → 129]
● Torque signal [ → 129]
IMPORTANT
Treatment, saving all treatment steps
The system will always save the entire treatment, including the step-
independent settings of the treatment and the specific settings of all
treatment steps, not just those of the current work step.
4.5 Dentist element
Implantology program
key.
4 Operation
.
129