Materials........................Intended use, indications and contraindications............Intended use ....................Indications ..................... Contraindications ..................Processing hints ....................... Scanning ....................... Processing the TiBase .................. Information for the dentist ................5.3.1 Sterilization..................5.3.2 Application in the mouth..............62 87 630 D3568 D3568.201.01.13.02 03.2017...
Sirona Dental Systems GmbH 1 Symbols used Operating Instructions TiBase Symbols used NOTICE! Observe operating instructions! This product is a medical device in accordance with Council Directive 93/ 42/EEC. 0123 For the USA only CAUTION: Federal law (USA) restricts sale of this device to or on the order of a physician, dentist, or licensed practitioner.
Sirona Dental Systems GmbH Operating Instructions TiBase Product description TiBase and Abutment Screw are products which are used for the digital acquisition of an implant position and for the restorative supply of implants. Instead of a deformation post to transmit the implant position to a model, a Scanbody is required in the digital process, which can be optically acquired in an effective way along with the mouth situation.
Page 5
Sirona Dental Systems GmbH 2 Product description Operating Instructions TiBase Table 1: Overview of the TiBase, Abutment Screws and tightening torques 62 87 630 D3568 D3568.201.01.13.02 03.2017...
Page 6
2 Product description Sirona Dental Systems GmbH Operating Instructions TiBase Depending on the connection, the following components are compatible: Table 2: Overview of compatible Scanbodies and mesostructure blocks Connection Scanbodies for Scanbodies for inCoris ZI meso F0.5 inCoris ZI meso F2...
CAUTION: Federal law (USA) restricts sale of this device to or on the order of a physician, dentist, or licensed practitioner. Indications TiBase titanium bases are attached to an implant as prosthetic titanium base for adhesion to mesostructures to restore function and aesthetics in the oral cavity.
2. Plug a suitable Scanbody (see Table 2 in the Section “Product description [ → 4]“) onto the TiBase so that it is seated free of gaps, and therefore flush while watching out for the intended guide groove in the Scanbody, guide it over the small cam on the TiBase. The scanbody is scannable without powder or scan spray.
The diameter of the TiBase must not be reduced e.g. by grinding. Shortening the TiBase is not permitted. The contact surfaces of the TiBase to the implant should not be sand- blasted or otherwise processed. Only the surfaces of the TiBase intended for gluing with a mesostructure must be sandblasted (50µm aluminum oxide, max.
The fabricator (dental technician) of the TiBase and the mesostructure must inform the dentist of the need to sterilize the abutment before inserting it in the patient's mouth! 5.3.2...