Configuring Control Options; Showing/Hiding" Chair Programs 3 And 4; Setting The Operating Mode Of The Start Program; Increasing The Travel Speed Of The Chair - Sirona teneo Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions (USA) TENEO
65 48 510 D3509
D3509.201.03.03.23 10.2016
4.15.4

Configuring control options

Operation of the entire dental treatment unit operation can be configured
in this dialog.
➢ Touch the
 The sub-dialog opens.
4.15.4.1

"Showing/hiding" chair programs 3 and 4"

In addition to the mouth rinsing position (S) and entry/exit position (0)
chair programs, the number of chair programs can be extended to 4 or
limited to 2. The setting affects all the operating modes of the Start
program.
➢ Touch the
 The selected field is highlighted orange.
4.15.4.2

Setting the operating mode of the Start program

The dental treatment unit can be set to the following operating modes:
● Field 1: Simple Start program
● Field 2: Advanced Start program
● Field 3: EasyMode Start program
For further information, see "Start program operating modes" [ → 47].
➢ Touch the
 The selected field is highlighted orange.

Increasing the travel speed of the chair

4.15.4.3
The travel speed can be increased for manual chair settings and
programmed movements of the chair. If this function is switched on, the
following chair movements are executed faster:
● OrthoMotion – Tilting the patient chair
● ErgoMotion – Tilting the patient couch and inclining the backrest
● Adjusting the chair height
Please note that motor noises become louder when the travel speed is
increased.
➢ Touch the
 If the key is highlighted orange, the patient chair travels at
increased speed.
4.15 Configuration of the dental treatment unit (setup)
Control options
key in the setup program.
Chair programs
key.
Operating mode
key.
Travel speed
key.
4 Operation
189