Clean/Disinfect The Cuspidor - Sirona teneo Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions (USA) TENEO
C
65 48 510 D3509
D3509.201.03.03.23 10.2016
5.5.2

Clean/disinfect the cuspidor

The cuspidor bowl, the tumbler holder A and the tumbler outlet B can be
sprayed and wiped with surface disinfectants.
Clean and disinfect the cuspidor bowl with a special cleaning agent. This
agent will also care for the drain lines of the cuspidor bowl.
NOTICE
Vacuum system, foaming cleaning agents
Domestic cleaning agents foam up.
Foaming cleaning agents often cause foam and water to be sucked into
the dry suction system. This can cause damage to the suction machine.
➢ Use only care, cleaning and disinfecting agents approved by Sirona,
see"Care, cleaning, and disinfecting agents" [ → 201].
The cuspidor bowl is attached to the water unit via a bayonet catch and
can be removed for thorough cleaning. The tumbler holder A can be left
attached when doing this.
Cuspidor bowl
CAUTION
If the dental treatment unit is switched on, the flushing and tumbler filling
functions can be activated even with the cuspidor bowl removed.
In this case, water would run onto the floor and could enter the dental
treatment unit.
➢ Switch the dental treatment unit off at the main switch before
removing the cuspidor bowl.
1. Remove the gold trapC.
2. Hold the cuspidor bowl firmly with both hands. Loosen the bayonet
catch by twisting the cuspidor bowl counterclockwise.
A rubber gasket is attached to the bayonet catch of the water unit to seal
its closure. Lubricate this gasket before reinserting the cuspidor bowl. For
lubricants, see "Care, cleaning and disinfecting agents." [ → 234]
Make sure that the bayonet catch snaps into place when you reinsert it.
After snapping into place, the higher side of the cuspidor bowl must be
located below the tumbler outlet.
5 Care, cleaning and maintenance by the practice team
5.5 Components of the water unit
233