Main Switch; Sirona Dental Systems Gmbh - Sirona teneo Operating Instructions Manual

4 Operation
4.1 Starting up the dental treatment unit
44

Main switch

4.1.2.2
Switching the dental treatment unit on
The main switch switches the dental treatment unit from Standby mode
to operational readiness.
Following switch-on, the operating system is booted and an automatic
self-test is performed.
✔
The power switch is turned on.
➢ Press the main switch on the dentist element.
 The LED of the main switch lights up on the dentist element.
 The dental treatment unit powers up and establishes operational
readiness.
If the next maintenance call is due in less than 42 days or the
maintenance deadline has already been exceeded, a message appears
on the touchscreen. For more information, please refer to "Inspection and
maintenance" [ → 261].
Switching the dental treatment unit to the Standby mode
On completing your work, you should switch the dental treatment unit off
with the main switch on the dentist element both for safety reasons and
to reduce its power consumption. Pressing the main switch turns the air
and water supply as well as all electronic components off. Only the
Standby circuit is still supplied with voltage. If no other devices are
operating using the external device connection and the dental treatment
unit is not equipped with an internal PC, the power consumption in
Standby mode is approximately 3 W.
➢ Press and hold the main switch on the dentist element until an
acoustic signal sounds. Then release the key.
 The dental treatment unit then shuts down and switches itself to the
Standby mode.
 The LED of the main switch goes out on the dentist element.

Sirona Dental Systems GmbH

Operating Instructions (USA) TENEO
65 48 510 D3509
D3509.201.03.03.23 10.2016