Sirona teneo Operating Instructions Manual page 277

Sirona Dental Systems GmbH
Operating Instructions (USA) TENEO
65 48 510 D3509
D3509.201.03.03.23 10.2016
10.4
Treatment program
10.4.1 Treatment selection
Assigning the burr drive
A burr drive must be assigned to each treatment type, i.e. endodontics
Treatment type Endo and Implant
(left key) and implantology (right key).
Display of assigned burr drive
The assigned burr drive is marked with an orange circle. Any position
marked with a gray circle also can be assigned.
Open endodontics administration
Used to access additional subordinate functions for endodontic
treatments; see "Endodontic administration" [ → 279].
10.4.2 Implantology
Calibrating the burr drive
A calibration must be performed each time you change or lubricate the
contra-angle handpiece.
The contra-angle handpiece is automatically checked during calibration.
This includes a measurement of motor current at different speeds to
assess the properties of the system.
Direction of rotation
Switches counterclockwise rotation ON/OFF
Activating/deactivating the NaCl flow
The flow volume settings are permanently shown in the
program on the touchscreen.
Activating NaCl rinsing
Rinses treatment areas with a sterile saline solution whenever the burr
instrument stops as long as key is actuated
Selecting a working step
Used to select the previous/next implantology work step
Memory key
Stores the settings of an implantology treatment
Opening the sub-screen
Used to access additional subordinate functions; see the following
function keys:
Preselecting NaCl rinsing and setting the flow rate
Preselection of the NaCl rinse to display the key in the Implantology
program. When the function is activated, the setting keys of the NaCl
rinse are shown in the sub-screen.
Torque acoustic signal
A beep is issued when approx. 75% of the set torque value is exceeded.
10 Overview of all function keys
10.4 Treatment program
Implantology
277