Sirona teneo Operating Instructions Manual page 258

5 Care, cleaning and maintenance by the practice team
5.7 Sanitation
max.
max.
258
3. Remove the instruments one after the other from the holder and hold
them over the cuspidor or over a watertight container with sufficient
capacity. Activate each instrument for approximately 15 seconds.
Afterward, return the instruments to the instrument holder.
4. Empty the rinsing tumbler and place the empty tumbler again below
the tumbler outlet.
5. If your dental treatment unit is equipped with a cuspidor, press the
tumbler filler twice.
Treating water lines with DENTOSEPT P waterline treatment solution
The water lines of the instrument hoses, SPRAYVIT hoses, and the
tumbler filler are filled with pure DENTOSEPT P.
1. Fill approx. 0.6 liters of DENTOSEPT P into the tank for waterline
treatment solution.
2. Switch the dental treatment unit on via the user interface and wait
approximately 3 minutes until the dental treatment unit is ready for
operation.
3. Remove the instruments one after the other from the holder and hold
them over the cuspidor or over a watertight container with sufficient
capacity. Activate each instrument for approximately 15 seconds.
Afterward, return the instruments to the instrument holder.
4. Empty the rinsing tumbler and place the empty tumbler again below
the tumbler outlet.
5. If your dental treatment unit is equipped with a cuspidor, press the
tumbler filler twice.
NOTICE
Tumbler filling, discolorations due to DENTOSEPT P
Splashes of pure DENTOSEPT P can result in discoloration of surfaces
if left for too long.
Any splashes should therefore be removed immediately using a moist
cloth.
Allow 24 hours reaction time
In order to effectively combat germs, you must allow the DENTOSEPT P
waterline treatment solution to act at least 24 hours, but for no longer than
3 days (maximum sanitation time).
Sirona Dental Systems GmbH
Operating Instructions (USA) TENEO
65 48 510 D3509
D3509.201.03.03.23 10.2016