Spectracom SecureSync User Reference Manual page 65

3.
4.
CHAPTER •
3 SecureSync User Reference Guide Rev. 18
NOTE – The eth0 port is the built-in SecureSync Ethernet port.
If the port is not already enabled, in the Edit Ethernet Ports Settings window, click the
Enable check box. The Edit Ethernet Ports Settings window will expand to show the
options needed to complete the port setup.
Fill in the fields as required:
Domain —This is the domain name to be associated with this port.
Enable DHCPv4 —Check this box to enable the delivery of IP addresses from a
DHCP Server using the DHCPv4 protocol. This box is checked by default. When
DHCP is disabled (the box is unchecked), the following fields will display and must
be completed:
Static IPv4 Address —This is the unique address assigned by the network
administrator. The default static IP address of the SecureSync unit is
10.10.200.1. In the format "
where each '
#
Netmask —This is the network subnet mask assigned by the network admin-
istrator. In the form "
page 36 for a list of subnet mask values.
IPv4 Gateway —The gateway (default router) address is needed if com-
munication to the SecureSync is made outside of the local network. By
default, the gateway is disabled.
DNS Primary —This is the primary DNS address to be used for this port. This
is set automatically if DHCP is enabled. When DHCP is disabled, DNS
Primary is set manually. In the format "
spaces, where each '
DNS Secondary —This is the secondary DNS address to be used for this
port. This is set automatically if DHCP is enabled. When DHCP is disabled,
" with no leading zeroes or spaces,
#.#.#.#
' is a decimal integer from the range [0,255].
xxx.xxx.xxx.xxx
#.#.#.#
' is a decimal integer from the range [0,255].
#
3.3 NETWORK Setup Pages
." See "Subnet mask values" on
" with no leading zeroes or
49