Frequency Out [1204-08, -1C, -26] - Spectracom SecureSync User Reference Manual

5.2.3.10 PPS Output: Status Window
To view the current settings of the 1PPS output , go to its Status window. For instructions, see:
"Viewing the Configuration of an Input or Output" on page 288.
The Web UI list entries for these cards are: 1PPS/Frequency BNC and 1PPS/Frequency RS-485.
The connector number is: J3 (BNC card); J1 (RS-485 card).
The Status window displays the following settings:
5.2.4

Frequency Out [1204-08, -1C, -26]

5.2.4.1 Frequency Out [1204-08, -1C, -26]: Specifications
CHAPTER •
5 SecureSync User Reference Guide Rev. 18
SecureSync starts numbering I/O ports with 0 (only 1PPS and 10 MHz out-
NOTE –
puts start at 1, because of the built-in outputs).
Signature Control : Displays the current configuration of Signature Control. See also: "Sig-
nature Control" on page 201.
Frequency : Indicates the configured frequency of the 1PPS output signal.
Offset : Displays the configured Offset (to account for cable delays or other latencies).
Edge : Shows if the on-time point of the 1PPS output is the rising or falling edge of the
pulse.
Pulse Width : Displays the configured Pulse Width of the 1PPS output. The Pulse Width is
displayed in nanoseconds (ns). The default Pulse Width is 200 milliseconds.
Outputs : (3) 1MHz, (3) 5MHz, or (3) 10 MHz Outputs
Signal Type and Connector :
5.2 Time and Frequency Option Cards
309