Procedure 11: Verifying Successful Installation - Spectracom SecureSync User Reference Manual

Figure 5-57:
b.
5.7.14 PROCEDURE 11: Verifying Successful Installation
Prior to beginning managing any features or functionality provided by the new card, it is advisable
to verify the successful installation by ensuring the card has been detected by the SecureSync
unit.
a.
b.
SecureSync Web UI, ≤ Version 4.x
Open a Web browser, and log in to the SecureSync Web UI. Navigate to the STATUS/INPUTS
and/or STATUS/OUTPUTS pages. Information displayed on these pages will vary depending
upon your option module card/SecureSync configuration (for example, the Multi-Gigabit Ethernet
option module card has both input and output functionality, and so is displayed in both pages).
Figure 5-58:
CHAPTER •
5 SecureSync User Reference Guide Rev. 18
Cable routing
Using the supplied cable ties, secure the cable, part number 8195-0000-5000, from the
option card to the white nylon cable tie holders fastened to the mainboard (see
figure above).
Caution: Ensure that screw holes on the card are properly lined up and secured to
the chassis before powering the unit up, otherwise damage to the equipment may
result.
Replace the chassis cover, and power on the unit.
To verify that the option card has been installed successfully and is being correctly recog-
nized by SecureSync:
If after an installation the card does not appear to be properly identified, it
NOTE –
may be necessary to update the SecureSync system software to the latest available
version.
Example STATUS/INPUTS page – SecureSync Web UI
5.7 Option Card Field Installation Guide
443