Oscillator Disciplining - Spectracom SecureSync User Reference Manual

3.6 OTHER Setup Pages
3.
Click OK in the message window that displays. The system will restore the configuration
using the bundled file stored at
/home/spectracom/xfer/config/
read the new configuration file. Once powered back up, SecureSync will be configured with
the previously stored file.
3.6.9.5 Restoring the Factory Defaults
For instructions on how to restore the SecureSync's configuration files to their factory default set-
tings, see: "Resetting All Configurations to their Factory Defaults" on page 218.
3.6.9.6 Cleaning the Configuration Files and Halting the System
To restore the configuration files to the factory defaults and immediately halt the system:
1.
Navigate to TOOLS/SYSTEM/Upgrade/Backup .
2.
In the Actions panel, click the *Clean Configuration and Halt* button.
3.
SecureSync restores the configuration files to the factory default, and halts the system so
that no changes are made to the factory default condition.
3.6.10

Oscillator Disciplining

The purpose of the internal oscillator is to provide SecureSync with an accurate and very stable fre-
quency source. This allows SecureSync to go into a holdover mode in the event that external time
188
SecureSync
.conf
CHAPTER •
3 SecureSync User Reference Guide Rev. 18
, then reboot in order to