Configuring A Timekeeper Ptp Master - Spectracom SecureSync User Reference Manual

If a TimeKeeper License is installed, you will also notice that the right button in the Main Nav-
igation bar is labeled MONITORING (not HELP), and under MANAGEMENT > NETWORK , there
is a PTP Setup option available:
Next, make sure that TimeKeeper is turned ON—see "En-/Disabling TimeKeeper" on page 235.
3.5.2

Configuring a TimeKeeper PTP Master

TimeKeeper is configured in the SecureSync Web UI, under MANAGEMENT > PTP Setup .
When setting up a PTP Master via TimeKeeper, the configured SecureSync interface (e.g.,
ETH0), detectable to the PTP network via its IP address, will send out synchronization packets
under the PTP protocol.
You can setup several PTP Masters, e.g. for different interfaces (if so equipped), or to serve dif-
ferent domains, or one for each PTP Version.
The following explains how to configure a PTP Master. Three procedures are described below:
CHAPTER •
3 SecureSync User Reference Guide Rev. 18
Procedure a): ADDING a PTP Master
Procedure b): EDITING a PTP Master
Procedure c): DELETING a PTP Master
3.5 Configuring TimeKeeper
127