Outline Of The Installation Procedure; Safety; Procedure 1: Unpacking - Spectracom SecureSync User Reference Manual

5.7.2

Outline of the Installation Procedure

The general steps necessary for installing SecureSync option cards are as follows:
1.
2.
3.
4.
5.
6.
7.
8.
5.7.3

Safety

Before beginning any type of option card installation, please carefully read the safety statements
and precautions under "SAFETY: Before You Begin Installation" on page 19.
5.7.4 PROCEDURE 1: Unpacking
On receipt of materials, unpack and inspect the contents and accessories (retain all original pack-
aging for use in return shipments, if necessary).
The following additional items are included with the
card(s). Some of the parts listed below will be required for the installation (depending upon option
card model, and installation location).
CHAPTER •
5 SecureSync User Reference Guide Rev. 18
NOTE – The installation procedure varies, depending on the type of option card and
the installation location.to be installed.
If adding or removing option cards that provide a reference, optionally backup your
SecureSync configuration (refer to Section: "PROCEDURE 2: Saving Reference Priority
Configuration", if applicable to your scenario or environment)
Safely power down the SecureSync unit and remove chassis cover.
Determine which slot the option card will be installed into.
Prepare slot (if required), and plug card into the slot.
Connect any required cables and secure option card into place.
Replace chassis cover, power on unit.
Log in to the SecureSync web interface; verify the installed card is identified.
Restore SecureSync configuration (if it had been backed up before, see above).
5.7 Option Card Field Installation Guide
ancillary kit for the field installation of option
433