Slave Properties
Master Properties
CHAPTER
•
5
SecureSync User Reference Guide Rev. 18
Clock Accuracy : A number describing the accuracy of the oscillator in the Grandmaster
Clock (see IEEE Standard 1588-2008, Section 7.6.2.5).
Offset Scaled Log Variance : See IEEE Standard 1588-2008 Section 7.6.3.
Priority1 : See IEEE Standard 1588-2008, Section 7.6.3.
Priority2 : See IEEE Standard 1588-2008, Section 7.6.3.
Negotiation Enabled : Reports whether the Unicast Negotiation option is Enabled or Dis-
abled.
Contract State : Reports the unicast contract state.
NEGO_OFF: Unicast negotiation option is Disabled.
NEGO_ON: Unicast negotiation option is Enabled.
REQUESTED: Unicast contract has been requested to the PTP Master.
GRANTED: Unicast contract has been granted by the PTP Master.
RENEWED: Renewal of the unicast contract has been requested to the PTP
Master.
CANCELED: Cancellation of the unicast contract has been requested to the PTP
Master.
Contract Duration : Duration of the unicast contract. Units: Seconds.
Contract Delay : Delay before the end of the unicast contract. Units: Seconds.
Message Interval : Announce Interval negotiated for the unicast mode. Units: log2
seconds.
Contract State : Reports the unicast contract state (see above 'Announce Contract State').
Contract Duration : Duration of the unicast contract. Units: Seconds.
Contract Delay : Delay before the end of the unicast contract. Units: Seconds.
Message Interval : Sync Interval negotiated for the unicast mode. Units: log2 seconds.
Contract State : Reports the unicast contract state (see above 'Announce Contract State').
Contract Duration : Duration of the unicast contract. Units: Seconds.
Contract Delay : Delay before the end of the unicast contract. Units: Seconds.
Log Message Interval : Delay_Resp Interval negotiated for the unicast mode. Units: log2
seconds
Unicast Negotiation : Reports whether the Unicast Negotiation option is Enabled or Dis-
abled.
5.5 Network Interface Option Cards
411
Need help?
Do you have a question about the SecureSync and is the answer not in the manual?
Questions and answers