Configuring The Gnss Receiver - Spectracom SecureSync User Reference Manual

entry), thereby reducing the time for the receiver to acquire and track the actual satellite signals.
This may lead to a significantly shorter time for SecureSync to deliver a GNSS-based timing signal
upon a "cold start" of the unit.
For information on how to configure A-GPS see "Configuring the GNSS Receiver" below.
3.6.15

Configuring the GNSS Receiver

To configure SecureSync's integrated GNSS Receiver:
1.
2.
3.
1
Typically, there is only one GNSS reference, numbered "0". Should your equipment be configured for several receivers, they will be numbered
sequentially.
CHAPTER •
3 SecureSync User Reference Guide Rev. 18
Navigate to INTERFACES > REFERENCES > GNSS Reference :
Click the GEAR button for the displayed 1 GNSS reference:
NOTE – If you choose the individual GNSS Reference (GNSS 0) directly through the
INTERFACES/REFERENCES drop-down menu, the GNSS Status window will
open. In this case, click the Edit button at the bottom of the GNSS Status window.
The GNSS 0 Edit window will display:
3.6 OTHER Setup Pages
205