Spectracom SecureSync User Reference Manual page 176

3.6 OTHER Setup Pages
The columns under each tab are:
Event —This is the event that will trigger the notification. The events under each tab will vary
according to context.
Mask Alarm —Check here to enable an alarm mask. Enabling an alarm mask for a given noti-
fication will prevent that notification from generating an alarm condition. Other notifications
for that event and logging of the event will still occur.
SNMP Trap —Check here to configure the event to trigger an SNMP Trap.
Email —Check here to configure the event to trigger an email notification.
Email Address —Enter the address to which the email should be sent when triggered by the
event.
For each event choose the notification you want and the email, if any, to which you want a noti-
fication to be sent. See "Configuring SNMP and Notifications" on page 85 for details about setting
up SNMP. See "Setting Up Notification Emails" on page 163 for information on setting up noti-
fication email.
For each event, only the notification options available can be configured. For example, a mask
alarm can be set for an In-Sync event, and a Not-in-Sync event, but not for an In-Holdover event.
3.
Click the Submit button at the lower right-hand corner of the page.
160
NOTE – Each event can be configured with the desired email address that is specific
to just that one event only. Note that only one email address can be specified in each
Email Address field.
CHAPTER •
3 SecureSync User Reference Guide Rev. 18