Rebooting Via Lcd/Keypad, Serial Port, Telnet, Ssh, Snmp; If A Secure Unit Becomes Inaccessible - Spectracom SecureSync User Reference Manual

3.
3.10.1

Rebooting via LCD/Keypad, Serial Port, Telnet, SSH, SNMP

The Reboot command can be initiated not only via the SecureSync Web UI, but also via the
keypad and LCD information display. See "Using the Keypad and Information Display" on page 28
for information on using the keypad to perform a system reboot.
With a serial connection to the front panel serial port, telnet connection or SSH connection, type
reboot
Reboot is also is available to be performed through an
on SecureSync commands, see "CLI Commands" on page 457.
Once the Reboot process has been initiated, the front panel LCD will display a "Power off
SecureSync " message, and the front panel LED time display will stop incrementing until
SecureSync has started booting back up again.
3.11

If a Secure Unit Becomes Inaccessible

Spectracom assumes that the customer is responsible for the physical security of the product.
Spectracom secure products are recommended to be locked in a secure enclosure, cabinet or
room. Unauthorized persons are not to be given access to the product nor should a serial cable and
terminal program be attached unless the system administrator is configuring or performing main-
tenance.
Access to a secure Spectracom product can become denied, if:
To regain access to the SecureSync unit, you must utilize the front panel keypad and LCD in order
to restore the
spadmin
The
"
defcert
Refer to "Using the Keypad and Information Display" on page 28 for information on using the
keypad and LCD information display.
CHAPTER •
3 SecureSync User Reference Guide Rev. 18
SecureSync will now be rebooted and be accessible again shortly thereafter.
<Enter> to reboot SecureSync.
your company disables HTTPS
loses the system passwords
allows the certificate to expire
deletes the certificate and private keys and deletes the host keys, or
forgets the passphrase.
spadmin
account's default password.
account can then be used to enable HTTPS using the "
" command generates a new self-signed SSL certificate.
3.11 If a Secure Unit Becomes Inaccessible
operation. For more information
snmpset
defcert
" command. The
225