Setting Up A Remote Log Server - Spectracom SecureSync User Reference Manual

4.11 Logs
for the Facility and Priority configurations of all logs that can be sent to a Syslog server are as fol-
lows:
Log Tab Name
Event
Alarms
Oscillator
GPS Qualification
Journal
Update
Timing
System
Table 4-2:
e.
Local Log —Enable or disable this particular log being stored inside SecureSync. When this
box is checked, the log will be stored in SecureSync.
f.
Remote Log —Configure the desired Syslog servers. When this box is checked, the par-
ticular log will be sent to a Syslog server.
In order for the logs to be formatted correctly for Syslog storage, all log entries are displayed using
Syslog formatting. Each log entry contains the date and time of the event, the source of the log
entry, and the log entry itself.
The "time" of all log entries will be in UTC, Local, TAI or GPS time, as configured in the "Time
scale" field that is located in the System Time Setup page (Setup/Time Management). Refer to
"Timescales, Offsets and Leap Seconds" on page 165 for information on configuring the System
Timescale.
4.11.7

Setting up a Remote Log Server

Storing log files on remote log servers supports advanced logging functionality.
To add remote log servers:
1.
Navigate to the Logs page through MANAGEMENT/OTHER/Log Configuration :
268
Facility
Local Use 7
Local Use 7
Local Use 7
Local Use 7
Local Use 7
Local Use 7
Local Use 7
Local Use 7
Factory default facility and priority codes
Priority
Alert
Critical
Debug
Warning
Notice
Information
Error
Emergency
CHAPTER •
4 SecureSync User Reference Guide Rev. 18