System Time Message - Spectracom SecureSync User Reference Manual

The user is presented with the SFTP prompt allowing interactive file transfer and directory nav-
igation.
Perform an SFTP file transfer from the device using Public Key with Pass-
phrase authentication
sftp -i ./id_rsa spadmin@10.10.200.5
Enter passphrase for key './id_rsa': mysecretpassphrase
sftp>
The user is presented with the SFTP prompt allowing interactive file transfer and directory nav-
igation.
3.3.5.9 Recommended SSH Client Tools
Spectracom does not make any recommendations for specific SSH clients, SCP clients, or SFTP
client tools. However, there are many SSH based tools available to the user at low cost or free.
Two good, free examples of SSH tool suites are the command line based tool OpenSSH running
on a Linux or OpenBSD x86 platform and the SSH tool suite PuTTY.
The OpenSSH tool suite in source code form is freely available at
must also provide an OpenSSL library, which can be found at
PuTTY can be found at:
3.3.6

System Time Message

The System Time Message is a feature used for special applications that require a once- per-
second time message to be sent out by SecureSync via multicast. This time message will be trans-
mitted before every 1PPS signal, and can be used to evaluate accuracy and jitter.
To set up and enable a System Time Message :
1.
2.
3.
CHAPTER •
3 SecureSync User Reference Guide Rev. 18
http://www.chiark.greenend.org.uk/~sgtatham/putty/
Navigate to MANAGEMENT > NETWORK > Actions panel, and select S ystem Time
Message . The Settings window will pop-up.
Populate the fields Multicast Address , Port Number and Message ID , and click Submit .
In the Network Services panel, enable the System Time Message .
3.3 NETWORK Setup Pages
www.openssh.org
though you
www.openssl.org
.
.
83