Spectracom SecureSync User Reference Manual page 197

3.
CHAPTER •
3 SecureSync User Reference Guide Rev. 18
Rotate —This option enables sequential rotation of the content displayed in the
information display as long as the keypad is not in use. Content will rotate through all
enabled content for installed options. When Rotate is selected, a further option
appears on the screen:
Rotation Delay —This option sets the duration in seconds for content display
during rotation before the next content screen is displayed. [Range = between
1 and 30 seconds]
Network (the default)—This option displays the current network settings. If an option
card is installed that provides additional network interfaces, there will be additional
network choices (i.e., Network: eth0, Network: eth1, etc.).
Status —This option displays current key status indications (such as NTP Stratum
level, TFOM –"Time Figure of Merit", Sync status and Oscillator lock status).
Position —This option displays latitude, longitude and elevation of the antenna.
Day of Year —This option displays the day of year (such as "Day of Year 104").
GNSS —This option displays the number of satellites currently being used (and the
strongest signal strength out of all these satellites) and their relative signal strengths
of all the receiver channels that are tracking satellites as a bar graph.
Date —This option displays the current date (such as "16 November 2014").
The date is based on the timescale configured for the information dis-
NOTE –
play. It is possible that a date other than "today's local date" may be shown, if
the configured time scale has already rolled over to its new date, though local
time has not yet rolled over to its new date.
Keys —This option is applicable to the SAASM GPS receiver option module only. The
front panel will display "NOT SUPPORTED" unless a SAASM receiver is installed.
None —This option configures the front panel 4-line information display to remain
blank unless the keypad is unlocked and in use.
In the Timescale/Local Clock field, choose the timescale or local clock you wish to use as
the time reference for the time shown on the front panel time display. The options available
are:
UTC
TAI
GPS
Any Local Clocks you have set up. The Time Zone and DST rules, as configured
under Time Management/Local Clocks will now be applied to the front panel time
display. For more information on Local Clocks see "Setting up a Local Clock" on
page 175.
3.6 OTHER Setup Pages
181