Spectracom SecureSync User Reference Manual page 416

5.5 Network Interface Option Cards
1.
Navigate to the Top panel of the GB PTP Edit window.
2.
Check the Enable PTP box.
Configuring Multicast Mode
To enter Multicast mode, perform the following steps:
1.
In the GB PTP Edit window, navigate to the Advanced tab.
2.
Select the Multicast Sync checkbox.
3.
Select the Multicast Sync Rate from the drop-down list.
4.
Select the Multicast Announce Rate from the drop-down list.
Configuring Unicast Mode
To enter the Unicast mode, perform the following steps:
1.
In the GB PTP Edit window, navigate to the Advanced tab.
2.
Confirm that Unicast Sync is checked. The 1204-32 PTP module should always respond to
unicast negotiations.
400 CHAPTER •
5 SecureSync User Reference Guide Rev. 18