General Setup - Spectracom SecureSync User Reference Manual

3.3.1

General Setup

To facilitate network setup, SecureSync provides the General Setup window, allowing quick
access to the primary network settings:
The General Settings window also displays the IPv4 address and default IPv4 gateway.
3.3.1.1 Accessing General Setup Settings
To access the General Setup window:
1.
Navigate to the General Setup screen through MANAGEMENT/NETWORK/General
Setup .
—OR:—
1.
Access the Network Management screen by clicking on NETWORK in the MANAGEMENT
drop-down menu and click the General Settings button in the Actions panel.
2.
The General Settings window will display.
CHAPTER •
3 SecureSync User Reference Guide Rev. 18
Hostname —This is the server's identity on the network or IP address. The default is
tracom
.
Default Gateway IPv6 —The gateway (default router) address is needed if communication
to the SecureSync is made outside of the local network. By default, the gateway is dis-
abled. In the format " ####.####.####.####.####.####.####.####
each ' ' is a hexadecimal value. When a DHCP server is not requested or is requested but
#
not available and DHCP IPv6 is enabled, the server will use this Default Gateway.
Default Port —When no specific port is identified for access to the network, the default port
is used. The factory default port is
eth0
.
3.3 NETWORK Setup Pages
Spec-
," where
45