Setting Up A New User In Nanosuite; Introduction; Exercise - Agilent Technologies Nano Indenter G200 User Manual

Setting Up a New User in NanoSuite

Introduction

Exercise

Agilent Nano Indenter G200 User's Guide
Defining users in NanoSuite enables you to customize the interface. By
the end of this section, you will be able to:
• Add a new user to NanoSuite that requires an entry password.
• Specify new directories for data storage.
• Define how NanoSuite appears when it starts up.
In this exercise, you will define a user with the following characteristics:
• Who has the highest privileges (for method access and data
manipulation).
• For whom the preferred method XP ISO 14577 Standard Test
Method is automatically loaded at login.
• Who has a password of NanoMan.
• For whom all samples are stored in a specific subdirectory.
To begin this exercise,
Launch NanoSuite.
1
At the User Login dialog box, select Agilent from the Name
2
drop-down menu.
Click OK.
3
If you are prompted to select a method in the Open Method dialog
4
box, click OK.
Select Users... from the User menu.
5
In the Users List dialog box, click the New... button.
6
In the User Configuration dialog box, complete the General tab
7
information as shown in
parameters as indicated:
User Name: Joe
a
Method Access Level: 9
b
User Privilege: Creator
c
Post Login Action: Load Default Method
d
Training Exercises G
Figure G-1 on page G-3. Adjust these
G-2