Agilent Technologies Nano Indenter G200 User Manual page 352

CAUTION
Agilent Nano Indenter G200 User's Guide
DCM II Tip Change Guide Tool and DCM II 1 mm Micro-Socket
2
Wrench, shown in Figure
Figure B-14Tools for DCM II tip change
Procedure
In NanoSuite, right-click in the Nano HandSet and select Initialize
1
to park the indenter and return the motion stage to its home position.
If you experience resistance during this step DO NOT force the pin,
instead attempt to change the angle of entry slightly until the pin slides
in easily.
Insert the locking pins which are installed at right angles to each
2
other:
Gently install the top-most locking pin first. The pin should slide
a
in easily with virtually no resistance. Slide the pin until
approximately half the pin length is out the far side of the head as
shown in Figure B-15
If there is resistance try the bottom slot first.
b
Next, install the second pin and slide it halfway through the head.
c
Dynamic Contact Module II B
B-14.
on page B-11.
B-10