Methods And Batches In Nanosuite; First Batch Test - Agilent Technologies Nano Indenter G200 User Manual

Methods and Batches in NanoSuite

First Batch Test

Agilent Nano Indenter G200 User's Guide
In NanoSuite, a method contains all of the instructions for performing a
single experiment and analyzing the resulting data. A batch specifies
where, when, and how many times the procedure described in a
particular method is performed. For example, a batch may specify the
following: beginning at 2:00 a.m., the procedure described by Method A
should be performed ten times on each of two samples.
When you launch NanoSuite, both a default method and batch are
automatically loaded. For the first example of this tutorial, you will not
use either the default batch or the default method. For the second
example of this tutorial, you will use both the default batch and the
default method.
Make sure that the fused silica sample provided with your instrument
1
is properly loaded in the center hole in the sample tray.
Click the Test tab (Figure 2-33
2
Figure 2-33The Test tab
From the Test page, click on the Batch Mode icon, shown in
3
Figure 2-34.
Figure 2-34Batch Mode icon in NanoSuite
This will open the Batch Configuration window.
Click New Batch in the Batch Configuration window as indicated in
4
Figure 2-35.
Quick Start Guide 2
) to reveal the Test page.
2-27