Allow Testing To Complete - Agilent Technologies Nano Indenter G200 User Manual

Agilent Nano Indenter G200 User's Guide
Periodically, NanoSuite will display the message shown in
This is normal because the indenter has not yet touched the surface of
the sample.
Figure 6-80NanoSuite message
Allow testing to complete (approximately 1 hour).
When testing is complete, go to the Review page.
21
Right-click anywhere in the Legend pane and select Select All Tests
22
from the resulting pop-up menu.
Delete any obviously aberrant tests, such as the aberrant test shown
23
in Figure 6-81:
Identify the test number by referring to the legend next to the
a
graph of results.
Right-click on the number of the aberrant test in the Legend pane.
b
Select Delete Test from the resulting pop-up menu.
c
Click Yes in the Test Deletion confirmation box
d
Right-click anywhere in the Legend pane and select Select All
e
Tests from the resulting pop-up menu to populate the graph.
Figure 6-81Example of an aberrant test
Commonly Used Procedures 6
Figure 6-80.
6-57