Agilent Technologies Nano Indenter G200 User Manual page 33

Agilent Nano Indenter G200 User's Guide
When the disk is warm, spread a small amount of crystalbond onto
3
the surface of the disk.
Place a microscope slide onto the surface of the sample disk and
4
press down on the slide with wooden contacts so that the slide seats
in the crystalbond, as shown in
with the wooden contacts until there are no bubbles between the
slide and the sample disk.
Figure 2-15Seating the slide into the crystalbond
Use pliers to remove the sample disk from the heating element and
5
allow the disk to cool to room temperature.
Turn the heating element off.
6
Mix a small amount of five-minute epoxy.
7
Using a wooden stick, place a small amount of epoxy on the slide, as
8
shown in Figure 2-16.
Figure 2-16Placing epoxy on the slide
Quick Start Guide 2
Figure 2-15. Move the slide around
2-14