Markers - Agilent Technologies Nano Indenter G200 User Manual

Markers

Agilent Nano Indenter G200 User's Guide
All of these markers discussed in this section are movable. For more
information on moving markers, see
page 272 in Chapter 6, "Commonly Used Procedures".
When viewing Penetration Curves With Roughness (nm) data, there are
six markers, outlined in
Table 1 Six Markers for Penetration Curves
Marker Character
a
b
C
d
e
M
When viewing Cross Profile Topography (nm) data, there are five
markers, outlined in Table
Table 2 Five Markers for Cross Profile Topography
Marker Character
0
1
O
P
G
"Setting the Surface Marker"
Table 1.
Marker Function
Beginning of the scratch
End of the pre-scratch profile
Critical point (start of fracture; appears only
when a fracture occurs)
End of Scratch
End of post-scratch profile
Beginning of the final profile
2.
Marker Function
Beginning of the cross profile
End of the cross profile
Top left pile up
Top right pile up
Bottom of the groove
Scratch Testing E
on
E-8