Switching To The Xp Head - Agilent Technologies Nano Indenter G200 User Manual

Switching to the XP Head

Agilent Nano Indenter G200 User's Guide
Switching from the DCM II head to the XP head is very similar to
Switching to the DCM II
Park the head by choosing System > Displacement Control Panel.
1
In the Displacement Control Panel dialog box, click Park Head.
2
Click CLOSE.
3
Choose Configure > Workspace....
4
In the Frame Workspace Configuration dialog box, select the XP
5
radio button as shown in
Figure B-9Set Frame Workspace Configuration to XP
Click OK.
6
Click Yes in the Caution! dialog box.
7
A message will be displayed, similar to that shown in
Figure B-10Request to restart NanoSuite
Click OK.
8
Dynamic Contact Module II B
Head.
Figure B-9.
Figure B-10.
B-6