Agilent Technologies Nano Indenter G200 User Manual page 245

Agilent Nano Indenter G200 User's Guide
As shown in Figure 6-37, the locking pins are installed at right angles to
each other.
Figure 6-37Insert locking pins at 90 degrees
Place two locking pins through the collar (bottom cover) and
2
indenter shaft by gently inserting them through the collar and shaft
with a twisting motion, using minimal force. If the first locking-pin
hole is difficult to penetrate, try the other hole first.
After inserting the locking pins, click OK in the Change Indenter Tip
3
dialog box, shown in
Gently dock the Tip-Change Tool
4
the retaining nut fits between the remover flats, illustrated in
Figure 6-38.
Figure 6-38Alignment of indenter shaft, tip and retaining nut
Commonly Used Procedures 6
Figure 6-36 on page 6-25.
with the Tip-Retaining Nut so that
6-26