Agilent Technologies Nano Indenter G200 User Manual page 243

Agilent Nano Indenter G200 User's Guide
Figure 6-33Select a clean location for testing
Click OK to continue.
13
NanoSuite will prompt you to repeat
14
sample in your batch.
Close the machine cabinet.
15
Periodically, NanoSuite will display the message shown in
This is normal because the indenter has not yet touched the surface of
the sample.
Figure 6-34NanoSuite message
Commonly Used Procedures 6
step 8 through step 13
Figure
for each
6-34.
6-24