Simulation Mode - Agilent Technologies Nano Indenter G200 User Manual

Simulation Mode

Agilent Nano Indenter G200 User's Guide
When NanoSuite controls hardware, you can have only one instance of
the software running. However, when you operate NanoSuite in
simulation mode, you can have multiple instances. This enables you to
compare multiple test methods or samples.
To operate NanoSuite in simulation mode:
Exit NanoSuite if it is open.
1
Choose Start from Windows.
2
Go to All Programs.
3
Choose Agilent NanoSuite > NanoConfig as shown in
4
Figure 4-118.
Figure 4-118NanoConfig command via Windows Start menu
At the User Login prompt, select Agilent from the Name drop-down
5
menu.
Click OK.
6
In the NanoSuite Configuration dialog box, select the Use
7
Simulation checkbox as shown in
NanoSuite 4
Figure 4-119 on page 4-106.
4-105