Replacing Booklet Staple Cartridge (For C3 Finisher With Booklet Maker) - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

3
Hold the tabs on both sides of a new booklet
staple cartridge, and insert it into the finisher
until it clicks.
4
Do the same for the booklet staple cartridge on the other side.
5
Close the finisher side cover.
Note

Replacing Booklet Staple Cartridge (for C3 Finisher with Booklet Maker)

When the C3 Finisher with Booklet Maker (optional) is installed and the booklet staple
cartridges need to be replaced, a message appears on the touch screen. When this message
appears, replace the booklet staple cartridges with new ones.
The Booklet Staple cartridge [R2] is running out
of staples. Please order a Booklet Staple
Cartridge [R2].
The Booklet Staple Cartridge [R2] is out of
staples or not fully inserted. Check the Staple
Cartridge [R2].
* : The messages above are for the Booklet Staple Cartridge [R2]. For the Booklet Staple Cartridge [R3], [R3] is displayed.
Important • The use of booklet staple cartridges not recommended by Fuji Xerox may degrade quality and
Note
1
Make sure that the machine is not operating,
and open the finisher front door.
• If the cover is not closed completely, a message appears and the machine will remain paused.
Message
performance. Use only booklet staple cartridges recommended by Fuji Xerox.
• If the booklet staple cartridge was not replaced properly, the message remains on the touch screen.
Follow the procedure and replace the booklet staple cartridge again.
• To order a booklet staple cartridge, contact our Customer Support Center.
Replacing Consumables
Solution
Prepare new staples.
Note • Staples cannot be replaced yet.
Replace staples with new ones.
3
93