Replacing Booklet Staple Cartridge (For Finisher-C1 With Booklet Maker Or D2-Staple-Finisher With Booklet Maker) - Fuji Xerox apeosport-IV 7080 Administrator's Manual

6
Push the staple cartridge into the finisher
until it clicks into place.
7
Close the finisher right door.
Note • If the finisher front door is not completely closed, a message will appear and the machine will
Replacing Booklet Staple Cartridge (for Finisher-C1 with Booklet Maker
or D2-Staple-Finisher with Booklet Maker)
When the Finisher-C1 with Booklet Maker (optional) or the D2-Staple-Finisher with
Booklet Maker (optional) is installed and the booklet staple cartridge needs to be
replaced, a message appears on the touch screen. When this message appears, load
a new staple case into the booklet staple cartridge.
This section explains how to replace the booklet staple cartridge in the Finisher-C1 with
Booklet Maker, as an example. You can apply the same procedures for the D2-Staple-
Finisher with Booklet Maker.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
• When the machine is in Energy Saver mode, exit Energy Saver mode by pressing the
• When you replace the booklet staple cartridge, press the <Machine Status> button and
Note • To order a booklet staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not operating,
and open the finisher front door.
2
While pressing the handle [R2] and handle
[R3] to the right (1), take the booklet staple
cartridge unit out of the finisher (2).
remain paused.
performance. Use only booklet staple cartridges recommended by Fuji Xerox.
<Energy Server> button and the <Machine Status> button on the control panel before you
replace the booklet staple cartridge.
check the current status for the booklet staple cartridge even when the control panel is lit.
Replacing Consumables
[R3]
[R2]
67
3