Replacing Booklet Staple Cartridge (For C3 Finisher With Booklet Maker) - Fuji Xerox ApeosPort-VII C7788 Quick Reference

Replacing Booklet Staple Cartridge (for C3 Finisher
with Booklet Maker)
When the C3 Finisher with Booklet Maker (optional) is installed and the booklet staple
cartridges need to be replaced, a message appears on the touch screen. When this message
appears, replace the booklet staple cartridges with new ones.
The Booklet Staple cartridge [R2] is running out
of staples. Please order a Booklet Staple
Cartridge [R2].
The Booklet Staple Cartridge [R2] is out of
staples or not fully inserted. Check the Staple
Cartridge [R2].
* : The messages above are for the Booklet Staple Cartridge [R2]. For the Booklet Staple Cartridge [R3], [R3] is displayed.
Important
The use of booklet staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Use booklet staple cartridges recommended by Fuji Xerox.
When the device is in Power Saver mode, wake the device from the Power Saver mode by pressing the Power
button and select [Machine Status] on the Home screen before you replace the booklet staple cartridge.
When replacing the booklet staple cartridge, select [Machine Status] on the Home screen and check the
current status for the booklet staple cartridge even when the touch screen is lit.
Note
If the booklet staple cartridge was not replaced properly, the message remains on the touch screen. Follow
the procedure and replace the booklet staple cartridge again.
To order a booklet staple cartridge, contact our Customer Support Center.
1
Make sure that the device is not operating, and open the finisher front door.

Replacing Booklet Staple Cartridge (for C3 Finisher with Booklet Maker)

*
Message
Solution
Prepare new staples.
Note
Staples cannot be replaced yet.
Replace staples with new ones.
131