Setup Via Web Interface Over Wlan (Gr25) - Leica GR10 Operational Manual

Operational Manual (Online Help)

Setup via Web interface over WLAN (GR25)

Only available for GR25 with WLAN radio installed.
Please note that this page describes a wireless ad-hoc connection to the default profile. For user defined ad-
hoc setups, please edit the described settings accordingly.
Step Description
1 Turn on the GR25.
2 Use the arrow buttons, go to Configuration / Network Config / WLAN and use the left button to enable the
WLAN radio.
A WLAN default profile is pre-configured on all GR25 with the WLAN hardware installed and the
GRL120 WLAN option installed.
3 Activate WLAN on your computer. It may be necessary to use a hardware or software switch.
4 On your computer, go to Start > Control panel > Network and Sharing Center.
5 Select to set up a new network.
6 Create a new wireless ad hoc (computer-to-computer) network.
7 Choose the security type to be "No authentication (Open)" and leave the security key field blank.
Enter the receiver's serial number for the network name.
8 Edit the network settings of your computers WLAN adapter:
IP address: 192.168.252.x
where "x" is a value between 1 and 255 (but not 2 as this is the IP address of the default WLAN profile of the
GR25)
Subnet mask: 255.255.255.0.
9 In the Control Panel, open the Windows Mobility Center and right click the new wireless network. Choose
"Connect" in the context menu.
10 Open a browser and type in the IP address: 192.168.252.2 to access the Web interface.
11 Use the default User name (Admin) and Password (12345678).
After logging in the first time you must create a new user account, including a new user name and password.
The
default user account can then be deleted. Refer to the GR Series Operational Manual (Online Help) for a
step-by-step
guide.
11 Configure the instrument for all required settings.
82
a. Left button
b. Right button
c. Up button
d. Cancel button
e. Down button
f. Enter button
g. Screen
h. ON/OFF button