Leica GR10 Operational Manual page 327

Infrastructure connection Step-by-Step
Step Description
1 Enable the WLAN adapter of the GR25 using either:
a. the web interface: Open the web interface and select Receiver Setup / Network Connections and
select WLAN
b. or by using the display and buttons: Go to Configuration / Network Config and then select WLAN,
make sure that wireless radio is shown as "enabled".
2 In the GR25 web interface, go to Receiver Setup / Network connections / WLAN.
3
Press Create new WLAN profile
4 Enter a unique name for the new WLAN profile.
Enter the SSID for the network to connect to or press
networks. In Network infrastructure select "Infrastructure" mode and the correct authentication and encryption
type as defined for the network to be connected to. Enter the correct network key.
5 Check if the access point is configured to assign an IP address automatically. If this is the case, make sure
Obtain an IP address automatically is activated. If the access point router does not assign IP addresses
automatically, deactivate Obtain an IP address automatically and enter the correct IP settings. Press
save the settings and return to the Network connections overview page.
6
Press Connect to connect to the new WLAN profile.
7 Enter the receiver's hostname or IP address in a browser window to access the web interface.
to open the New WLAN profile page.
Find wireless network to search for available wireless
9: How to
to
325