Leica GR10 Operational Manual page 261

Step Action
Register at DynDNS service: Go to one of the supported DynDNS services and register for an account.
1 At registration enter the hostname you want your receiver to be accessed with. Enable wildcard use.
Mail exchanger functionality is not necessary. Click here for further information on Hostname rules.
Get an APN profile from your Internet Service provider:
In order to connect to the Internet from your receiver, you need to get the APN from your provider and
also a list of all ports that are open and available for use. This profile needs to be activated for each SIM
card you want to use for Internet access on your receiver. When using Email and FTP push, make sure
that the relevant SMPT and FTP ports are open. Also for DynDNS service, either port 80, 8245 or 443
have to be available. The profile also needs to contain the IP of at least one DNS server that is run by
your provider.
By default, port 80 (outbound) is used when discovering the receiver's externally visible IP address.
Unfortunately many firewall and proxy setups block this port. To bypass this problem, port 8245 is
2
normally used for accessing checkip.dyndns.org. Please and make sure this port is open.
The GR/GM Series receiver offers 3 choices of DynDNS hosting service. The access ports for these are
as follows:
•
•
•
Please make sure the appropriate ports are open depending on which service you are using.
Apply correct port numbers: After you received a list of the available ports, go to Receiver setup / Web
3 server and change the HTTP port accordingly. Also the FTP control port and data port range might
need to be changed.
Connect a GRPS phone to the receiver: To connect to the Internet via GPRS please refer to Receiver
4 setup / Network connections and apply the correct configuration on the mobile Internet tab. Make
sure to activate the mobile Internet gateway as the default gateway.
Configure DynDNS functionality: Enter all necessary settings as described below. After pressing Store,
5
the receiver should connect to the DynDNS service and show the current IP of the receiver in the
message log.
•
Setting Descriptions
The table below describes the settings that can be configured on the DynDNS page.
Field Description
Service provider
Lists all available DynDNS service providers. Select the provider that the hostname of your
receiver has been registered with.
The GR/GM Series receiver supports
DynDNS.com 8245
No-ip.com 8245
Two-DNS.de 80
•
DynDNS.com
•
No-ip.com
6: Context sensitive help
259