Incoming Data Stream Wizard: Configure Serial Port - Leica GR10 Operational Manual

Operational Manual (Online Help)

Incoming data stream wizard: Configure Serial port

Background Information
This mode allows the receiver to receive data on a physical serial port.
This page allows the user to change the settings on the instrument's serial port.
Setting Descriptions
The table below describes the settings that can be configured on the Configure serial port page.
Setting
Connected to
Baud rate, Parity, Data
bits, Stop bits
Flow control
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Incoming data streams.
180
Description
Only available on GR25. Select the physical serial port for data transmission
•
Serial port 1
•
Serial port 2
For the GR/GM10, Serial port 1 is configured automatically as there is
only one serial port available.
Select the port settings for the communication between the receiver and the serial port.
Defines which kind of handshake is used.
•
None: No handshake.
•
RTS/CTS: Handshake in both directions.
to continue to the next wizard step.