Incoming Data Stream Wizard: Configure Ntrip Client - Leica GR10 Operational Manual

Operational Manual (Online Help)

Incoming data stream wizard: Configure Ntrip client

Background Information
This mode allows the receiver to act as an Ntrip client, connect to an Ntrip Caster and receiver correction data.
Setting Descriptions
The table below describes the settings that can be configured on the Configure Ntrip client page.
Setting
Ntrip caster address
TCP/IP port
Mount point
Source table
User name
Password
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Incoming data streams.
Ntrip client connections
•
If an Ntrip client connects to the Ntrip caster and tries to connect to a non-existing mount point or a mount point that
does exist but is currently not receiving any data from an Ntrip server (source), the Ntrip caster will return an "Invalid
mount point" error message. If the Ntrip client is a GR/GM receiver, it will continuously try to reconnect every 5 s.
•
If an Ntrip client connects to the Ntrip caster and tries to connect to a mount point using a wrong user name or
password, the Ntrip caster will return an "Authentication failed" error message. If the Ntrip client is a GR/GM receiver,
it will try to reconnect every 5 s for 30 s.
•
If an GR/GM receiver Ntrip client is connected to the Ntrip caster and no data is received from the Ntrip caster for
more than 15 s, the Ntrip client will assume that the connection is not valid anymore. This is necessary as it may
happen that the connection from the Ntrip caster to the Ntrip client may be interrupted, leaving the Ntrip client
assuming that the connection is still available. Please make sure the data rate connected to the Ntrip caster is higher
than 15 s. If the connected Ntrip client is a GR/GM receiver, it will continuously try to reconnect every 5 s.
Related Topics
Status: Ntrip caster
Ntrip caster: Overview
Ntrip caster: Caster tab
Ntrip caster: Mount points tab
178
Description
The hostname or IP address of the Ntrip caster to connect to.
The valid IP range is from 1.0.0.0 to 223.255.255.255.
Enter the TCP/IP port open on the Ntrip Caster for clients to connect to. The default Ntrip
Caster port number is 2101.
Enter the mount point from which the data is to be received.
The mount point is the identifier of a data stream on an Ntrip Caster. A list of all the available
mount points running on an Ntrip caster can be requested via the source table icon.
User authentication may be needed to connect to a mount point.
The source table is empty until the
Ntrip caster is successful, the drop down list can be opened and lists all the available mount
points on the configured Ntrip caster. If a mount point is selected from the list, it will
automatically appear in the mount point input field.
Or enter the mount point manually.
Enter the user name for authentication on the configured mount point.
For some mount points authentication is not needed. In these cases, the fields can be left
blank.
Enter the password for authentication on the configured mount point.
For some mount points authentication is not needed. In these cases, the fields can be left
blank.
Get source table icon is used. If the connection to the
to continue to the next wizard step.