Leica GR10 Operational Manual page 153

Time Activate or deactivate time slicing.
slicing
Select activate to delay the sending of the real time message. This is required when a real time message
from different reference stations are sent on the same radio channel.
No. of Only visible when Time slicing is checked.
reference
Select the number of reference stations in use from where real time messages are sent on the same radio
stations
channel.
Time slot
Select the time slot. This field is only visible when Time slicing is checked.
The time slot represents the actual time delay. The number of possible time slots is the number of reference
stations in use. The time delay equals 1 s divided by the total number of reference stations. If two reference
stations are used, the time delay is 0.50 s. Therefore, the time slots are at 0.00 s and at 0.50 s. With three
reference stations, the time delay is 0.33 s. The time slots are at 0.00, 0.33 and 0.66 s.
The following settings are dependent on the selected version and message type.
Data rate
Coordinate rate
Info rate
Message xx rate
Message xx repeat
Message 9nr. Satellites
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Outgoing data stream.
Select the rate at which data will be sent.
Select the rate at which coordinates will be sent.
Select the rate at which the Reference Station information, such as point ID will be sent.
Enter the rate at which the selected messages will be sent out.
Enter the number of times the selected messages will be repeated.
The number of satellites to be included in message 9.
to continue to the next wizard step.
6: Context sensitive help
151