Outgoing Data Stream Wizard: Configure Ntrip Server (Source) - Leica GR10 Operational Manual

Operational Manual (Online Help)

Outgoing data stream wizard: Configure Ntrip server (source)

Background Information
This mode allows the receiver to act as Ntrip Server, and to provide data to an Ntrip Caster.
In terms of TCP/IP, the Ntrip server mode is in fact a TCP client mode. As an Ntrip Server, the receiver connects to a caster
and starts to stream data.
Setting Descriptions
The table below describes the settings that can be configured on the Configure Ntrip server (source) page.
Setting
Use local caster
Ntrip caster IP address
TCP/IP port
Mount point
Choose mount point
Password
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Outgoing data stream.
Ntrip server connections
•
If an Ntrip server (source) connects to the Ntrip caster and tries to connect to a non-existing mount point, the Ntrip
caster will return an "Invalid mount point" error message. If the Ntrip server (source) is a GR/GM receiver, it will try to
reconnect every every 10s for 30 minutes.
•
If an Ntrip server (source) connects to the Ntrip caster and tries to connect to a mount point that is already receiving
data from another Ntrip server (source), the Ntrip caster will return a "Mount point taken" error message. If the Ntrip
server (source) is a GR/GM receiver, it will try to reconnect every 10s for 30 minutes.
•
If an Ntrip server (source) connects to the Ntrip caster and tries to connect to a mount point using a wrong password,
the Ntrip caster will return an "Authentication failed" error message. If the Ntrip server (source) is a GR/GM receiver,
it will not try any reconnects.
•
If an Ntrip server (source) is connected to the Ntrip caster and no data is received from the source for more than 15
s, the Ntrip caster will disconnect the Ntrip server (source). This is necessary as it may happen that an Ntrip server
(source) disconnection may not be done properly, leaving the Ntrip caster assuming that the connection is still
available. If the Ntrip server (source) now tries to reconnect, a "mount point taken" message would be issues and the
connection not be allowed. To prevent this, the connection is regularly checked for data transmission. Please make
158
Description
If the Ntrip caster on this receiver is active and mount points are defined, a data stream can
be sent directly to this caster and distributed to Ntrip clients.
Activating this check box will automatically set the correct settings for the local caster and
provide a list of all the available mount points on the local Ntrip caster.
The hostname or IP address of the Ntrip caster to connect to.
The valid IP range is from 1.0.0.0 to 223.255.255.255.
Enter the TCP/IP port to connect to on the Ntrip caster.
Enter the mount point.
The mount point is the identifier of a data stream on an Ntrip Caster. It is needed to provide
data to an Ntrip Caster.
Only available when "Use local caster" is activated. It shows a list of all the mount points
configured on the local Ntrip caster. A mount point can be selected and will then appear in the
mount point field. The mount point name can be edited later.
It is possible to enter a mount point name that is not yet defined on the local Ntrip caster.
Store the data stream and define the mount point afterwards.
Enter the source password.
The source password, as configured for the selected mount point, is required to authenticate
a stream sending data to the Ntrip caster.
to continue to the next wizard step.