Remote Access Wizard: Connection - Leica GR10 Operational Manual

Operational Manual (Online Help)

Remote access wizard: Connection

Setting Descriptions
The table below describes the settings that can be configured on the Connection page.
Setting Description
Connection type
Select the connection type that is needed for Leica GNSS Spider or other OWI based software to
connect to the receiver.
TCP/IP server
TCP/IP client
Ntrip server (source)
Serial port
Radio
GSM / Modem / CDMA -
dial up
Press to change settings. Press
Press to cancel and return to Spider and remote access: Overview .
238
This setting allows the receiver to works as a TCP server,
allowing TCP clients to connect to the receiver's NET
ports.
This setting allows the receiver to act as a TCP client and
connect to a configured IP address and port. This way no
port has to be opened in the firewall on the receiver side
to allow clients to connect to it.
This setting allows the receiver to act as an Ntrip source
and connect to a configured Ntrip caster IP address, port
and mount point. This way no port has to be opened in the
firewall on the receiver side to allow client connections.
When using this setup the receiver transmits data using
the Ntrip protocol.
This setting allows connecting the receiver directly to a
PC's communication port via a GR/GM Series data cable
with a RS232 connector.
Use two, 2-way radios to allow Leica GNSS Spider or
other OWI based software to configure the receiver.
This setting allows Leica GNSS Spider or other OWI
based software to use a modem to dial into a modem
connected to the GR/GM Series and configure the
receiver.
to continue to the next wizard step.