Outgoing Data Stream Wizard: Configure Serial Port - Leica GR10 Operational Manual

Operational Manual (Online Help)

Outgoing data stream wizard: Configure Serial port

Background Information
This mode allows data to streamed out of the physical serial port.
This page allows you to change the settings of the instrument's serial port.
Do not select the connection type Serial Port if you have a radio/modem/phone connected to the
physical serial port. In this case you must select the connection type Radio or GSM/Modem/CDMA -
dialup. The serial port settings for these devices are configured in Receiver settings: Device
Management.
Setting Descriptions
The table below describes the settings that can be configured on the Configure serial port page.
Setting
Connected to
Baud rate, Parity, Data
bits, Stop bits
Flow control
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Outgoing data stream.
160
Description
Only available on GR25. Select the physical serial port for data transmission
•
Serial port 1
•
Serial port 2
For the GR/GM10, Serial port 1 is configured automatically as there is
only one serial port available.
Select the port settings for the communication between the receiver and the serial port.
Defines which kind of handshake is used.
•
None: No handshake.
•
RTS/CTS: Handshake in both directions.
to continue to the next wizard step.