Outgoing Data Stream Wizard: Configure Gsm / Modem / Cdma - Dial Up - Leica GR10 Operational Manual

Operational Manual (Online Help)

Outgoing data stream wizard: Configure GSM / Modem / CDMA - dial up

Background Information
This mode allows data to be transmitted with an attached GSM, Modem or CDMA - dial up service device. There are a number
of default devices defined in the Receiver settings: Device Management page.
The device settings can be edited in the Receiver settings: Device Management page.
New devices can be created in the Receiver settings: Device Management page by creating a copy of an
existing device.
Only one dial up connection is supported. Make sure to delete existing dial up connections before adding a
new one. Check page Status > Port Summary to see which dial up connections are configured.
Setting Descriptions
The table below describes the settings that can be configured on the Configure GSM / Modem / CDMA - dial up page.
Setting
Device
Pin code
Puk code
Connected to
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Outgoing data stream.
162
Description
Select the device name.
Only devices defined in the Receiver settings: Device Management page are available for
selection.
Enter the pin code for the devices SIM card.
The puk code is a security code for the SIM card for some devices. The puk codes needs to
be entered when the pin code has been entered incorrectly more than three times. The puk
will unblock the SIM card.
Only available on the GR25.
Select the physical serial port for data transmission
•
Serial port 1
•
Serial port 2
For the GR/GM10, Serial port 1 is configured automatically as there is
only one serial port available.
For slot in devices, this field is not available, the slot-in port is selected
automatically.
to continue to the next wizard step.