Gnss Management: Tracking General - Leica GR10 Operational Manual

Operational Manual (Online Help)
GNSS management: Tracking

GNSS management: Tracking General

Background information
If an external oscillator is selected but not connected, the receiver will not track any satellite signals.
If an external oscillator is selected but not connected and the fallback option is activated, the internal clock will
be used.
Changing the Satellite system, Satellite signals and/or Cut-off angle interrupts logging and streaming. If any of
these settings are changed while a logging session is active, the current file will be finalized and a new file
will start to be logged.
GPS and GLO L2C cannot be activated while an incoming real time data stream is activated for fixed position
calculation.
If you want to enable GPS and GLO L2C tracking make sure to first disable the incoming real time data
stream.
Exclusive GPS L2C tracking is not possible. This means that enabling GPS L2C only, but not GPS L2P(Y),
will implicitly activate L2P(Y) data to be tracked on satellites that do not provide L2C.
If L2P(Y) and L2C is enabled, L2P(Y) will be tracked for all GPS satellites and L2C where available.
Setting Descriptions
The table below describes the settings that can be configured on the Tracking General tab.
Satellite system
134
Description
Activate the satellite system(s) to be tracked.
The availability of the different satellite systems depends on the installed receiver options.
When activating a satellite system, the default frequencies are activated if the
corresponding option key is available. Default frequencies are the frequencies used for
position calculation. Non default frequencies can be activated manually. When deactivating
a satellite system, all frequencies of the respective satellite system are deactivated.
Activate / deactivate the check boxes to track the different signals of each satellite system.
All signals other than L1 are only available if the corresponding option key is installed.
The Tools / Options page provides an overview of all purchased options that are currently
activated on the receiver and a detailed description of all available options.
If needed, specify a certain SBAS satellite systems in the Track sat. syst. list box or leave
at Automatic to have the receiver automatically select the SBAS system. Alternatively,
select All visible to use all SBAS satellite systems that are tracked by the receiver.