Incoming Data Stream Wizard: Configure Tilt - Leica GR10 Operational Manual

Incoming data stream wizard: Configure Tilt

Background Information
Tilt devices (such as the Leica NIVEL210) are used for measuring inclinations. The data from the tilt device is logged together
with the GPS raw observations into MDB files. When logging RINEX files, the tilt data is written into a special auxiliary file.
No tilt data is logged unless a logging session is configured in GNSS management: Logging sessions and the
incoming data stream is active.
Setting Descriptions
The settings on this screen define the input port and parameters for incoming tilt device measurements.
Setting
Device
Data rate
Connected to
The following default settings are used for communication between the Tilt device and receiver. They cannot
be edited.
NIVEL210 default communication settings
Communication setting
Port name
Baud rate
Parity
Data bits
Stop bit
Flow control
Description
Select the device. The Leica NIVEL210 and the Measurement Specialities D-Series NS-
XX/DMG2 are the only tilt devices supported by the GR/GM receiver.
The XX in the name of the device "DSeries NS-XX/DMG2" is a place
holder for different versions corresponding to the measuring range of the
tilt device. Currently, versions with 5°/15°/30° measuring range are
available. The different versions use the same interface and can now all
be used together with RefWorx.
Select the rate at which data is requested from the tilt device.
Only available on the GR25.
Select the physical serial port for data transmission
•
Serial port 1
•
Serial port 2
For the GR/GM10, Serial port 1 is configured automatically as there is
only one serial port available.
Default setting
Serial Port (P1).
9600
None
8
1
No handshake. The handshake used between the receiver and the tilt device.
6: Context sensitive help
169