Receiver Setup: Residential Gateway - Leica GR10 Operational Manual

Receiver Setup: Residential Gateway

Background Information
The Residential Gateway configuration enables the receiver to work as a gateway to the internet. This means that IT devices
which are connected to the receiver via a TCP/IP connection can share the internet connection of the receiver.
Setting Descriptions
The table below describes the fields in the Residential gateway page.
Setting
Activate
WAN interface
LAN interface
LAN interface IP address
LAN network IP address
range
Restore default
values
Press the save icon to store the settings.
Description
Activate the check box to enable the residential gateway functionality. When activated
the residential gateway settings are visible and can be edited.
When the residential gateway functionality is enabled, DHCP will
be disabled for the selected LAN interface. This means that static
IP addresses will be used for the LAN interface.
Select the interface to be used to establish the connection to the internet (WAN = Wide
Area Network).
The following interfaces can be used (if available):
•
Mobile internet
•
Ethernet
•
WLAN
Select which interface should be used to establish the connection to the device
connected to the receiver which should get access to the internet. Usually this will be a
laptop or another mobile device.
The following interfaces can be used (if available):
•
Ethernet
•
WLAN
Shows the fixed IP address of the LAN interface.
Shows the IP address range available for the LAN interface.
Press to fill the form with factory default settings and store.
The restore default button fills all fields with the default values and
stores these values. Pressing the save button is not necessary.
When accepting the confirmation message, all settings on this
page are overwritten with the default settings.
6: Context sensitive help
227