Network Connections: Ethernet - Leica GR10 Operational Manual

Network connections: Ethernet

Background Information
Ethernet configuration enables the receiver to be accessed via the Internet when an Ethernet cable is connected.
Setting Descriptions
The table below describes the settings that can be configured on the Ethernet tab.
IP settings
Obtain an IP address automatically
IP address
Subnet mask
Default gateway
DNS settings
Preferred DNS server
Alternate DNS server
Restore default
values
Description
Activate to obtain the IP address automatically using DHCP.
For more information on how to access the web interface in a
non-DHCP network, please refer to Setup in a non - DHCP
network.
Enter the Internet protocol address of the receiver.
This field can only be edited if the Obtain an IP address automatically field is
disabled.
The IP address is a 32 bit number which must be obtained from the network
administrator or the Internet service provider. The valid IP range is from 1.0.0.0
to 223.255.255.255.
Enter the subnet mask assigned to the subnet the receiver is connected to.
A subnet mask allows IP networks to be subdivided for security and performance
purposes.
This field can only be edited if the Obtain an IP address automatically field is
disabled.
Enter the Gateway. This is the IP address of a local default IP router on the same
network. It is used to forward traffic to destinations beyond the local network.
This field can only be edited if the Obtain an IP address automatically field is
disabled.
A gateway is the connection or interchange point that connects separate IP
networks. For example, a Local Area Network may need a gateway to connect it
to the Internet. The valid IP range is from 1.0.0.0 to 223.255.255.255.
Description
The DNS (Domain Name System) server IP address which was obtained via
DHCP if the option Obtain IP address automatically field is checked. Otherwise
the DNS server can be entered manually.
The alternate DNS server IP address which was obtained via DHCP if the option
Obtain IP address automatically field is checked. Otherwise the DNS server
can be entered manually.
Press to fill the form with factory default settings.
The restore default button fills all fields with the default values
and stores these values. Pressing the save button is not
necessary. When accepting the confirmation message, all
settings on this page are overwritten with the default settings.
6: Context sensitive help
217